NEW!

IMS's Microstepping MForce MicroDrive is an ultra compact microstepping driver that delivers unsurpassed smoothness and performance achieved through IMS's advanced 2nd generation current control.

By applying innovative techniques to control current flow through the motor, resonance is significantly dampened over the entire speed
range and audible noise is reduced.

Microstepping MForce MicroDrives accept a broad input voltage range from +12 to +48 VDC, delivering enhanced performance and speed. Oversized input capacitors are used to minimize power line surges, reducing problems that can occur with long runs and multiple drive systems. An extended operating range of -40° to +85°C provides long life, trouble free service in demanding environments.

The high, per phase output current of up to 2 Amps RMS, 2.8 Amps Peak, allows the extremely compact MForce MicroDrive to control of a broad array of motors from size 8 to size 34.

The microstepping drive accepts up to 20 resolution settings from full to 256 microsteps per full step, including: degrees, metric and arc minutes. These settings may be changed on-the-fly or downloaded and stored in nonvolatile memory with the use of a simple GUI which is provided. This eliminates the need for external switches or resistors. Parameters are changed via an SPI port.

Power and signal interface connections are accomplished with either a pluggable locking wire crimp, terminal strip or 12.0" (30.5cm) flying leads. Motor phases are connected via a pluggable 4-pin locking wire crimp connector.

The Microstepping MForce MicroDrive is a compact, powerful and inexpensive solution that will reduce system cost, design and assembly time for a large range of applications.

FEATURES:

	Ultra Compact, high performance
	microstepping driver
	Advanced 2nd generation current control for
	exceptional performance and smoothness
	Single supply: +12 to +48 VDC
	Low cost
	Extremely compact
	High output current up to 2 Amps RMS, 2.8
	Amps peak (per phase)
	20 microstep resolutions up to 51,200 steps
	per rev including: degrees, metric, arc
	minutes
	Optically isolated logic inputs will accept
	+5 to +24 VDC signals, sourcing or sinking
	Automatic current reduction
	Configurable: motor run/hold current; motor
	direction vs. direction input; microstep
	resolution; clock type: step and direction,
	quadrature, step up and step down;
	programmable digital filtering for clock and
	direction inputs
	Set-up parameters may be switched
	on-the-fly
	Power and signal interface options:
	pluggable locking wire; pluggable terminal
	strip; 12.0" (30.5 cm) flying leads
	Graphical user interface (GUI) for quick and
	easy parameter setup

Please contact our Sales Staff for pricing information.