AMP's Si5580 is a programmable stepper drive/indexer packaged in a rugged steel case painted black with white epoxy silkscreen. Integral heat sink, mounting brackets, switch covers and connectors are included with each Si5580. The drive/indexer has been matched with twelve recommended NEMA 23 and 34 motors and comes with all operating software necessary to create a complete stepper motion solution.

The Si5580 includes AMP's Microsoft Windows based Si™ software language for quick set up and ease of use. The Si™ is ideal for stand-alone operation. For more experienced users, with software development expertise, the Si5580 also comes with AMP's Si Command Language (SCL) programming instruction set. SCL allows for control of the Si™ drive from a host PC or PLC thus permitting the user to perform a variety of motion, I/O tasks, and system status retrieval via the host.

Multiple axis applications are handled by our SiNet™ Hub Programmer, which gives you the ability to control up to 8 Si™ drives, either stepper or servo on the same hub. Not only can you coordinate up to eight motors, the hub also has access to the inputs and outputs of all the drives, providing your program with up to 64 inputs and 24 outputs. You can also use AMP's MMI, which allows the machine operator to enter specific motion commands. Factory set to operate at 110-volt input; the Si5580 can be set by the user to operate at 220-volt input by a simple switch selection.

Pluggable screw terminal blocks are provided for the I/O, motor and AC power inputs. Mating connectors, programming cable with computer interface connector, as well as all operating software are provided with each Si™ drive. The Si5580 is both CE and TUV compliant.

FEATURES:

	Si™, Si Command Language (SCL) or
	SiNet™ Hub programming languages
	included with drive
	AC input 110 V or 220 V switch selectable,
	50-60 Hz
	DC bus voltage 75 VDC full load, 80 VDC
	nominal
	Software selectable motor current from
	0.5 - 5.5 amps/phase
	Software selectable motor resolution from
	2,000 to 50,800 steps per revolution
	Software selectable idle current reduction 0,
	25%, 50% or 100%
	Eight optically isolated programmable inputs
	5 - 24 VDC. 2,200 ohms internal resistance.
	Can be configured for sinking (NPN) or
	sourcing (PNP) signals.
	Three optically isolated programmable
	outputs 12 - 24 VDC, 100mA maximum
	One optically isolated output 5 VDC
	dedicated to fault out
	RS-232 for PC/MMI communications
	Over current and over temperature
	protection
	440 watts of usable power
	Screw terminal connectors
	Dual, MOSFET H-bridge, 3 state, pulse width
	modulated amplifier switching at 20-30 KHz
	Ideal for 4, 6 or 8 leaded step motors NEMA
	sizes 23 and 34
	CE and TUV compliant

Please contact our Sales Staff for pricing information.