AMP's Si2035 is a programmable stepper drive/indexer packaged in a rugged steel case painted black with white epoxy silkscreen. Integral heat sink, mounting brackets, switch covers and connectors are included with each Si2035. The drive/indexer has been matched with nine recommended NEMA 11, 14, 17 and 23 motors and comes with all operating software necessary to create a complete stepper motion solution.

The Si2035 includes AMP's Microsoft Windows based Si™ software language for quick set up and ease of use. The Si is ideal for stand-alone operation. For more experienced users, with software development expertise, the Si2035 also comes with AMP's Si Command Language (SCL) programming instruction set. SCL allows for control of the Si drive from a host PC or PLC thus permitting the user to perform a variety of motion, I/O tasks and system status retrieval via the host.

Multiple axis applications are handled by the SiNet™ Hub Programmer, which gives you the ability to control up to 8 Si drives, either stepper or servo on the same hub. Not only can you coordinate up to eight motors, the hub also has access to the inputs and outputs of all the drives, providing your program with up to 64 inputs and 24 outputs. You can also use AMP's MMI which allows the machine operator to enter specific motion commands. Factory set to operate at 110-volt, the Si2035 can be set by the user to operate at 220-volt input by a simple switch selection.

Pluggable screw terminal blocks are provided for the I/O, motor and AC power inputs. Mating connectors, programming cable with computer interface connector as well as all operating software are provided with each Si drive.

FEATURES:

	Si, Si Command Language (SCL) or SiNet
	Hub programming languages included with
	drive
	AC input 110 V or 220 V switch selectable,
	50-60 Hz
	DC bus voltage 28 VDC full load, 35 VDC
	nominal
	Software selectable motor current from
	0.2 - 2.0 amps/phase
	Software selectable motor resolution from
	2,000 to 50,800 steps per revolution
	Software selectable idle current reduction
	0%, 25%, 50% or 100%
	8 optically isolated programmable inputs
	12 - 24 VDC. 2,200 ohms internal resistance.
	Can be configured for sinking (NPN) or
	sourcing (PNP) signals
	Four optically isolated programmable outputs
	30 V max, 100 mA max
	One 0 - 5 VDC analog output (supported
	by SCL only)
	RS-232 for PC/MMI communications
	70 watts of usable power
	D type and screw terminal connectors
	Dual H-bridge, pulse width modulated
	amplifier switching at 26 KHz
	Ideal for 4, 6 or 8 leaded step motors NEMA
	sizes 11, 14, 17 and 23
	Optional Man Machine Interface (MMI)
	allows machine operator to enter specific
	motion parameters

Please contact our Sales Staff for pricing information.