AMP's PDO 5580 is a stepper drive packaged in a rugged steel case painted black with white epoxy silk screen. Integral heat sink, mounting brackets, switch covers and connectors are included with each drive. The drive has been matched with twelve recommended NEMA 23 and 34 motors in order to create a complete stepper motion solution.

The PDO5580 provides the user with four modes of operation to choose from, Self Test, Pulse & direction, Joystick or Oscillator. The specific operation mode desired is selected during set up via DIP switch. DIP switches are also provided for setting the drive's step resolution as well as the motor current.

Self Test Mode us used for troubleshooting. If you are unsure about the motor or signal connections to the drive you can use the self-test.

Pulse & Direction Mode allows the PDO5580 to receive step pulses from an indexer such as the Applied Motion's Si-100 or Si-1, or from a PLC or any other external controller.

Joystick Mode allows speed and direction to be determined by an external analog voltage. STEP and DIR inputs can be used for limit switches. SPEED input selects speed range. LO SPEED and HI SPEED pots adjust the 2 speed ranges.

Oscillator Mode can control speed by onboard potentiometers and/or by an external analog voltage. STEP input starts and stops the motor. DIR input controls direction of rotation. SPEED input selects the speed range.

The PDO5580 also provides a Tach Output and Enable Input.

A Tach Out Signal is provided for measuring the motor speed. It generates 100 pulses per revolution. If connected to a frequency counter, speed reads out in revs/second with two decimal places.

ENABLE allows the user to turn off the current to the motor by setting this signal to logic 0. The logic circuitry continues to operate, the drive "remembers" the step position even when the amplifier is disabled.

Factory set to operate at 100-volt input; the PDO5580 can be reset by the user to operate at 220-volt input by a simple switch selection.

Pluggable screw terminal blocks are provided for the motor, AC input and 8-position signal input/output. Mating connectors are provided with the drive.  The PDO5580 is both CE and TUV compliant.

FEATURES:

	AC input 110 v or 220 V switch selectable,
	50-60 Hz
	DC bus voltage 75 VDC full load, 80 VDC
	nominal
	Switch selectable motor current from
	0.5-5.5 amps/phase
	Pulse and Direction mode: switch selectable
	200 to 50,800 steps/rev
	Oscillator/Joystick mode: 12,800 steps/rev
	Switch selectable idle current reduction,
	0 or 50%
	Optically isolated inputs/outputs
	Speed, Enable: optically isolated,
	differential 5-24 V logic
	Step, Direction: optically isolated
	differential 5-12 V logic
	Wiper: 0-5 VDC analog signal
	Tach & Fault output: isolated
	phototransistor. Output is 100 pulses per
	motor revolution, 50% duty cycle
	Internal Pot: Low speed 0-5 rps; high speed
	0-25 rps; accel/decel 1-250 rev/sec/sec
	External Speed, Pot or joystick 3 terminal
	type, 1k-10k ohms
	Self test, switch selectable
	440 watts of usable power
	Overtemp, overcurrent and surge protection
	Screw terminal connectors
	Dual, MOSFET H-bridge, 3 state, pulse width
	modulated amplifier switching at 20-30 KHz
	Ideal for 4, 6 or 8 leaded step motors NEMA
	sizes 23 and 34
	CE and TUV compliant

Please contact our Sales Staff for pricing information.