AMP's 2035XD step motor drive is a two axis, software configured step/direction or oscillator drive. Drives can be quickly and precisely configured using AMP's eXposition™ software and a Windows PC.

When configured for pulse/direction mode, the two drives can be commanded by the step and direction signals available from many PLcs and step motor indexers.

In oscillator mode, the drives generate their own acceleration and deceleration profiles and are commanded by digital run/stop signals. These signals can be supplied by PLCs, mechanical switches, single board computers or other motion control devices. Speeds may be fixed or can be set "on the fly" by 0 to 5 volt analog signals.

FEATURES:

	DC bus voltage 12-35 VDC motor supply
	(including ripple)
	Software programmable motor current,
	0.1- 2.0 amps/phase
	Software programmable step size,
	200-50800 step/rev
	Automatic idle current reduction
	Four optically isolated digital inputs:
	step/run 1, step/run 2, direction 1,
	direction 2
	Two analog inputs, 10 bit resolution,
	0 - 5 VDC
	On-board oscillator generates step pulses
	and accel/decel ramps
	Fixed speed or proportional to analog input
	Optically isolated 5-24 VDC Tach output for
	monitoring speed
	70 watts of usable power per axis
	Screw terminal connectors
	Dual H-bridge, inaudible PWM amplifier
	3 state, pulse width modulated current
	control, switching at 20-30 KHz
	Drives 4,6 or 8 lead size 11, 14, 17, 23
	step motors

Please contact our Sales Staff for pricing information.